v3i dead needs help

[jls]

hi to gsmserver team i recieve a v3i which no power.i try to put phone in boot mode but phone will not go to bootloader mode...so i don't know what is the bootlader version or firmware of the phone.i tried to repair pds using v3i_R474,v3i_R479,v3i_R3443H3..in doing repair pds no problem at all..then after i repair pds i flash the phone with fullflash file all went thru with no problem with the three version,but still the phone won't power on..what can be the problem with this one?pls i need your reply..thanks in advance

SmartMoto 2.28
S-Card: ****** Smart-Clip dongle, v 1.41, assigned Smart-Clip: ****** Europe, initializing... OK
Clip serial: *****, version: 3.19, initializing... OK
Searching for phone... found S Blank Neptune LTE2, getting test interface... interface not found
Switching to flash mode... OK
Reading phone boot version... 3.00
Reading flash id... Intel - 28F256L18B
Reading flash id/2... Intel - 28F128L18T, OK
Phone group: V235,V360,V360v,V3i,V3r,L7,L7e,L7v,L71,K1,Z3
Hardware IMEI: 353608011452664
IMEI OTP status: locked
Security area saved to "PDS for S Blank Neptune LTE2 353608011452664 (4).mbk"
Login request... OK
Writing flash section 2 of 2... 100% (23.9 Kb/sec)
Restarting phone... OK
Searching for phone... found S Blank Neptune LTE2
Switching to flash mode... OK
IMEI OTP status: locked
Repair PDS request... OK
Performing PDS repair... OK
Writing flash section 1 of 1... 100% (13.9 Kb/sec)
Please write a corresponding Full_flash file to phone to complete repair
Writing flash section 2 of 2... 100% (63.4 Kb/sec)
Flash completed!



br

[dcg28052]

Hello, I have the similar problem before, the process was hung and run the battery down, it lost every thing then, but in your case, first I would go update the Smart-Clip to the 3.24, S-card 1.47, then download the SmartMoto 2.36, then after you finish writing the full flash, go to back-up area, and clik on the restore security area, that's how it brought mine back to live, good luck.